Introduction; Before Using The Product For The First Time; Physical Installation - Martin PAR 2 RGBW Zoom User Manual

Introduction

The RUSH PAR 2 RGBW Zoom™ is a bright single-lens LED PAR Can with
fully premixed color from 12 RGBW LEDs and a 10 to 60° motorized zoom. It
offers electronic dimming and strobe and comes with a flexible bracket for floor
or truss mounting.
The PAR 2 RGBW Zoom can be controlled using any DMX-compliant
controller. The fixture is supplied with a 1.5 m (5 ft) power cable (local power
plug not included) and a mounting bracket with two legs.

Before using the product for the first time

1. Read Safety information on page 4 before installing, powering, operating
or servicing the fixture.
2. Unpack and ensure that there is no transportation damage before using
the fixture. Never attempt to operate a damaged fixture.
3. If the fixture is not going to be hard-wired to an AC mains power source,
install a local power plug (not supplied) on the end of the supplied power
cable.
4. Before operating, ensure that the voltage and frequency of the local power
source match the mains power requirements of the fixture.
5. Check the Martin Professional website at www.martin.com for the most
recent user documentation and technical information about the fixture.
RUSH by Martin™ user manual revisions are identified by the revision
letter at the bottom of the inside cover.
When the fixture is powered on for the first time, it may smoke slightly as it
warms up, but this will only last a few minutes and is no cause for concern.

Physical installation

Read 'Safety information' on page 4 before installing the
fixture.
The fixture is designed for indoor use only and must be used in
a dry location with adequate ventilation. Ensure that none of the
fixture's ventilation slots are blocked and ensure that the product
is fastened to a secure structure or surface.
8 RUSH PAR 2 RGBW Zoom User Manual