Impedance Selector Switch; Connecting The Power Supply Cords - Yamaha DSP-E800 Owner's Manual

Av processor/amplifier
Hide thumbs Also See for DSP-E800:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

IMPEDANCE SELECTOR Switch

WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit may be
damaged.
If this unit fails to turn on when STANDBY/ON (POWER) is pressed, the IMPEDANCE SELECTOR switch may not be
fully slide to either position. If so, slide the switch to either position fully when this unit is in the standby mode.
Select the right or left position according to the impedance of speakers in your system. Be sure to move this switch only
when this unit is in the standby mode.
(Europe model)
IMPEDANCE
SELECTOR
IMPEDANCE SELECTOR
AC OUTLET
SET BEFORE POWER ON
SWITCHED
100W MAX.
REAR
: 4 MIN./SPEAKER
CENTER
: 4 MIN./SPEAKER
REAR
: 8 MIN./SPEAKER
CENTER
: 8 MIN./SPEAKER

Connecting the Power Supply Cords

AC OUTLET (SWITCHED)
To AC outlet
(Europe model)
IMPEDANCE SELECTOR
AC OUTLET
SET BEFORE POWER ON
SWITCHED
100W MAX.
REAR
: 4 MIN./SPEAKER
CENTER
: 4 MIN./SPEAKER
REAR
: 8 MIN./SPEAKER
CENTER
: 8 MIN./SPEAKER
SWITCHED
Switch potision
Speakers
Left
Rear
Center
Right
Rear
Center
After completing all connections, connect the AC power
cord to an AC power outlet. Disconnect the AC power cord
if you will not use this unit for a long period of time.
U.K. and Europe models .................................... 1 OUTLET
Use this outlet to connect the power cords from your
components to this unit. The power to the AC OUTLET is
controlled by this unit's STANDBY/ON (or POWER). This
outlet will supply power to any connected component
whenever this unit is turned on. The maximum power (total
power consumption of components) that can be connected
to the AC OUTLET is 100 W.
CONNECTIONS
Impedance level
The impedance of each speaker must be
4
or higher.
The impedance must be 4
or higher.
The impedance of each speaker must be
8
or higher.
The impedance must be 8
or higher.
E-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents