Impedance Selector Switch; Connecting The Power Supply Cords - Yamaha DSP-A5 Owner's Manual

Natural sound av amplifier
Hide thumbs Also See for DSP-A5:
Table of Contents

Advertisement

CONNECTIONS

IMPEDANCE SELECTOR Switch

WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit may be
damaged.
If this unit fails to turn on when STANDBY/ON (or POWER) is pressed, the IMPEDANCE SELECTOR switch may not
be fully slide to either position. If so, slide the switch to either position fully when this unit is in the standby mode.
Select the right or left position according to the impedance of speakers in your system. Be sure to move this switch only
when this unit is in the standby mode.
IMPEDANCE
SELECTOR

Connecting the Power Supply Cords

AC OUTLETS (SWITCHED)
(Europe model)
SWITCHED
16
(Europe model)
To AC outlet
If you use
left position
If you use one pair of main
speakers, the impedance of
each speaker must be 4
higher.
Main
speakers
If you use two pairs of main
speakers, the impedance of
each speaker must be 8
higher.
Rear speakers The impedance of each
speaker must be 6
higher.
Center
The impedance must be 6
speaker
or higher.
After completing all connections, connect the AC power
cord to an AC power outlet. Disconnect the AC power cord
if you will not use this unit for a long period of time.
Europe model .................................................... 2 OUTLETS
U.K. model .......................................................... 1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC OUTLET(S)
is controlled by this unit's STANDBY/ON (or POWER and
STANDBY). These outlets will supply power to any
connected component whenever this unit is turned on. The
maximum power (total power consumption of components)
that can be connected to the AC OUTLET(S) is 100 W.
right position
If you use one pair of main
speakers, the impedance of
or
each speaker must be 8
higher.
If you use two pairs of main
speakers, the impedance of
or
each speaker must be 16
higher.
The impedance of each
or
speaker must be 8
higher.
The impedance must be 8
or higher.
or
or
or

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents