Safety Precautions; Esd Precautions; Component Compatibility - Infortrend EonNAS Pro Series Hardware Manual

Precautions

Safety Precautions

Read these instructions before you install, operate, or transport the system.
Setup the system at a site where the ambient temperature stays lower than 40C.
Install the power source socket outlet near the enclosure where it is easily accessible.
Secure airflow clearance around the enclosure:
- Secure an 18 to 20cm clearance around the enclosure.
- Do not cover the enclosure openings.
- Do not leave the drive bays empty as it will affect the airflow efficiency.
NEVER remove more than one hard disk drive tray out of the enclosure at the same time!
Secure each hard disk drive using its retaining screws.
Put the power cords and other cables away from foot traffic. Do not place things over the
power cords and make sure they do not rest against data cables.
Ensure that the correct power range is being used before powering the device.
If the enclosure is not used for a long time, disconnect it from mains to avoid transient
over-voltage.

ESD Precautions

Avoid touching the PCB boards or connector pins on the hard drives.
Avoid dust, debris, carpets, plastic, vinyl, and tyrofoam in your work area.
Do not remove the hard disk drive from its anti-static bag before installation takes place.
Hard drives must not be stacked on top of each other without their protective drive trays. Even
when drives are fixed in the drive trays, contacting the exposed PCB or rear-side connector
interface may damage the hard drives.

Component Compatibility

The use of compatible components is strongly recommended to ensure compatibility, quality
and normal operation with your system. Please contact your vendor for a list of compatible
components.