2.5
Checking Out the System
Message
KVH TracVision SA
Software Version
Initializing
Search Mode 1
Search Mode 2
Search Mode 3
Reacquisition
RF Signal Error
AZ Motor Error
EL Motor Error
Message
Searching for satellite –
please stand by
Searching for program guide –
please stand by
54-0149 Rev. B
Definition
Displays for 5 seconds at startup
Current software version
Alternates with "KVH TracVision SA"
System initializing
Antenna Unit in Search Mode 1
Antenna Unit in Search Mode 2
Antenna Unit in Search Mode 3
System is reacquiring the satellite
RF signal detector has no signal at input
Fault detected in azimuth drive subassembly
Fault detected in elevation drive subassembly
Definition
The IRD is powered up and
doesn't detect the satellite signal.
The system has found the satellite,
but has been turned off for more
than approximately four hours. This
message appears for about
10 seconds.
The DISH Network and some
newer IRDs (e.g., the Sony A50)
give priority to internal IRD
messages rather than on-screen
messages. KVH recommends that
the maintenance port must be used
to read installation-related
messages on a PC.
Table 2-2
Table 2-3
Installation
2-13