KVH Industries TRACVISION SA User Manual page 57

A Guide to TracVision SA
F-4
F.4
Report Target Location
Table F-4
Function:
Command:
Argument:
Response:
Report RF Signal Strength
Function:
Command:
Argument:
Response:
Report IRD Signal Quality
Function:
Command:
Argument:
Response:
Report IRD Type
Function:
Command:
Argument:
Responses:
Target and Signal Commands
reports the target (satellite) location in the baseplate
frame and uses the saved satellite position
TGTLOCATION
none
Target Location = E XXX, A XXXX
reports the modified signal strength from the RF power
detector circuit, and applies the RF gain and offset
computed during LNB calibration
SIGLEVEL
none
Signal Strength = XXXX
reports the signal strength from the IRD; it uses the last
received signal quality and initiates a new signal quality
request command from the IRD
SIGQUALITY
none
Stale Signal Quality = XX
reports the IRD connection type as DSS, EchoStar,
untested, or none
IRDTYPE
none
IRD type has not been tested yet.
IRD type is Echostar.
IRD type is DSS.
IRD type cannot be determined.