+12v DC
yyyy
+12v DC
yyyy
Ground
Shield
2.4.3 Connecting the Antenna RF Signal
Cable to the IRD
54-0149 Rev. B
Rocker
Switch
yyyy
+12v DC
yyyy
Ground
Shield
Splice
To Vehicle
Figure 2-17
When wiring the rocker switch, it is
recommended that the shield wire
from the TracVision SA be
connected to the shield from
vehicle power.
When shipped from the factory, the
#1 liquid-tight fitting is sealed with a
rubber stopper. Leave the stopper n
the fitting unless you are going to
install a dual output LNB and be
connect a second RF cable to the
TracVision SA.
Figure 2-18
Installation
2-11