Chapter 1. General Description; Specifications - Sharp UX-A255U Service Manual

Facsimile machine
Table of Contents

Advertisement

CHAPTER 1. GENERAL DESCRIPTION

[1] Specifications

Automatic dialing:
Imaging film:
Memory size* :
Modem speed:
Transmission time* :
Resolution:
Automatic document feeder: 10 pages max. (letter/A4, 20 lb paper)
Recording system:
Halftone (grayscale):
Compression scheme:
Display:
Applicable telephone line:
Paper tray capacity:
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.
30 numbers
Initial starter roll: (included with
machine): 32 ft. (10 m) (approx. 30
letter-size pages)
Replacement roll (not included):
UX-5CR 164 ft. (50 m) roll (one roll
yields approx. 150 letter-size pages)
504 KB (approx. 30 average pages
with no voice messages recorded and
ECM turned off, or 20 minutes of voice
documents in memory)
14,400 bps with automatic fallback to
lower speed
Approx. 6 seconds
(only when ECM is on)
Horizontal:
203 pels/inch (8 dots/mm)
Vertical:
Standard: 98 lines/inch
(3.85 lines/mm)
Fine/Halftone: 196 lines/inch
(7.7 lines/mm)
Super fine: 391 lines/inch
(15.4 lines/mm)
Thermal transfer recording
64 levels
MH, MR, MMR
16-digit LCD display
Public switched telephone network
Letter: Approx. 50 sheets (20-lb. copier
paper at room temperature; maximum
stack height should not be higher than
the line on the tray)
Legal: 5 sheets
Recommended paper weight is 20-lb.
Copy Bond
Compatibility:
Input document size:
Effective scanning width:
Effective printing width:
Contrast control:
Reception modes:
Copy function:
Telephone function:
Power requirements:
Operating temperature:
Humidity:
Power consumption:
Dimensions (without
attachments):
Weight (without
attachments):
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp
special mode, excluding time for protocol signals (i.e., ITU-T phase
C time only).
1 – 1
UX-A255U
ITU-T (CCITT) G3 mode
Automatic feeding:
Width: 5.8 to 8.5"
(148 to 216 mm)
Length: 5.5 to 11"
(140 to 279 mm)
Manual feeding:
Width: 5.8 to 8.5"
(148 to 216 mm)
Length: 5.5 to 23.6"
(140 to 600 mm)
8.3" (210 mm) max.
8.3" (210 mm) max.
Automatic/Dark selectable
TEL/FAX/TAD
Single/Multi (99 copies/page)
Yes
(cannot be used if power fails)
120 V AC, 60 Hz
41 - 95 F (5 - 35 C)
Maximum: 85 % RH
Stand-by: 3.6 W
Maximum: 100 W
Width: 12.9" (327 mm)
Depth: 7.6" (193 mm)
Height: 6.4" (163 mm)
Approx. 6.2 lbs. (2.8 kg)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents