JVC KD-NX5000 Instructions Manual page 46

Setup Menu (continued)
Selectable settings
(Initial setting)
Select the angle of the unit measured by the supplied gauge. (See
also the Installation/Connection Manual.)
1: -5.0 0 to 1.0 0
2:
1.0 0 to 6.0 0
3:
6.0 0 to 14.0 0
~:
14.0
0 to 32.0 0
• It is not recommended to install the main unit at an angle of
more than 30 0
;
otherwise, the malfunction may result.
Select whether to use WAAS and EGNOS to increase the accuracy
of positioning.
Off:
Cancels.
On:
Activates.
Select the language used for on-screen information and voice
guidance.
English US, Espanol,
Fran~ais
Reset the calibration data in the following cases:
• When you reinstall the unit to another car.
• When you change
Installation Angle.(1&
above)
• When you replace or rotate the tires.
Once this is carried out, the learning data is cleared. Calibration
starts when you exit from the menu.
(1&
[9])
Subscribe to traffic services.
1&
[41]
Select the measuring units for distance.
km
I
m, mi 1ft
Select the measuring units for coordinate degrees.
Deg I Min I Sec, Deg
I
Milli j Micro
If you find your current position displayed on a wrong place on the
map, use this setting to correct your position.
Adjust the position with
~~
...
T,
then the direction with ...
T.
*4 This setting is shared with the
Language
setting in AVMenu
(~
[90]).
.... 46