JVC KD-NX5000 Instructions Manual page 115

• The connected audio device cannot be
controlled.
Causes/Remedies
This unit can be connected with one Bluetooth
cellular phone and one Bluetooth audio device at a
time. While connecting a device, this unit cannot
be detected from another device. Disconnect
currently connected device and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the
device detects the unit, select Open on the unit
to connect the device.
(~
[84J)
• Enter the same PIN code for both the unit and
target device.
• Select the device name from Special Device,
then try to connect again.
(~
[84J)
Adjust the microphone unit position.
• Place the Bluetooth audio device nearer to the
adapter.
• I\1ove the car to place where you can get a better
signal reception.
• Place the Bluetooth audio device nearer to the
adapter.
• Disconnect the device connected for "Bluetooth
Phone."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect
the device again.
Check whether the connected audio device
supports AVRCP (Audio Video Remote Control
Profile).
*
For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
Troubleshooting
775 ~