JVC KD-NX5000 Instructions Manual page 106

About sounds reproduced through the rear terminals
• Through the analog terminals (Speaker out/LINE OUT):
2-channel signal is emitted. When playing a multi-channel encoded disc, multi-channel signals are
downmixed. (l@f' [92] Down
Mix.)
• Through DIGITAL OUT (optical):
Digital signals (Linear PCM, Dolby Digital, DTS, MPE'G Audio) are emitted through this terminal.
To reproduce multi-channel sounds such as Dolby Digital, DTS, and MPEG Audio, connect an
amplifier or a decoder compatible with these multi-channel sources to this terminal, and set
D.
Audio Output correctly. (l@f' below.)
Output signals through the DIGITAL OUT terminal
Output signals are different depending on the D. Audio Output setting (l@f' [92]).
48 kHz, 16 bits stereo Linear PCM DTS bitstream
32/44.1/48 kHz, 16 bits Linear PCM
32/44.1/48 kHz, 16 bits Linear PCM
DTS bitstream
DTS bitstream
MPEG bitstream
Stream/PCM
Dolby Digital bitstream
Dolby Digital bitstream
Dolby Digital bitstream
Dolby Digitall
PCM
48 kHz, 16 bits stereo Linear PCM
48 kHz, 16 bits stereo Linear PCM*
44.1 kHz, 16 bits stereo Linear PCM
48 kHz, 16 bits stereo Linear PCM
48 kHz, 16 bits stereo Linear PCM
44.1 kHz, 16 bits stereo Linear PCM
44.1/48 kHz, 16 bits Linear PCM
48 kHz, 16 bits stereo Linear PCM
44.1 kHz, 16 bits stereo Linear PCM
48 kHz, 16 bits stereo Linear PCM
48 kHz, 16 bits stereo Linear PCM
PCM Only
48 kHz, 16 bits stereo
Linear PCM
48 kHz, 16 bits stereo
Linear PCM
48 kHz, 16 bits stereo
Linear PCM
D. Audio Output
Playback disc
*
While playing some DVDs, digital signals may be emitted at 20 bits or 24 bits (at their original bit rate) through the
DIGITAL OUT terminal ifthe discs are not copy-protected.