Maintenance And Adjustments; Cutting Range - Honda HRC7018 Owner's Manual

MAINTENANCE &ADJUSTMENTS
-
5. Install the linchpin(s) in the
adjusting bar. Place the
1 l/i
adjusting lever in its storage
position and secure it with
31~~
2
its spring pin.
4
2%
4'/2
3
5
a'/2
Cutting Range
5'/2
To change the cutting range
of your mower you will reposition the front caster wheels on
the mower deck and change the drive axle pivot position on
the power unit.
Always shut off the engine and remove the key before
changing the cutting range.
Front Cutting Range Adjustment
1. Raise and support the front of the mower deck.
2. Remove the 4 bolts holding the caster wheel assembly to the
mower deck.
3. Reinstall the caster wheel
assembly in the alternate set
of holes.
Upper 4 holes = Low Range.
Lower 4 holes = High Range
4. Repeat the procedure for the
other caster wheel and lower
the deck to the ground.
5. Tighten the 4 bolts on each
caster wheel assembly to
31 ft-lb (42 Nom).
(LOW RANGE SHOWN)
6. Follow the procedures for Front Wheel Adjustment (page 58)
to set the desired cutting height.
7. Lower the mower deck to the ground.
60