Honda HRC7018 Owner's Manual page 67

MAINTENANCE 8, ADJUSTMENTS
4. Raise the caster post and
insert and lock the pin.
5. Repeat the procedure on
the other caster wheel.
Do not change the location
of the washers on the
caster post.
,
Rear Wheel Adjustment
The rear wheels are
WASHER LOCATIONS
adjustable within their range in l/2 inch increments by placing
the adjusting bar in the drive axle in one of the 5 holes on the
power unit. The adjusting lever helps you raise and lower the
power unit.
1. Remove the linchpin to remove the adjusting lever from its
storage position.
\\
2. Remove the linchpin from
one or the other ends of the
adjusting bar.
3. Place the adjusting lever in
one of the holes on the
power unit to raise the
power unit until the
adjusting bar can be
removed.
4. Use the adjusting lever to
align the holes in the
desired position and install
the adjusting bar.
(If you are adjusting from
one end of the range to the
other, you may have to
install the adjusting bar in
an intermediate position to
relocate the adjusting lever
for better leverage.)
59