Honda HRC7018 Owner's Manual page 71

MAINTENANCE & ADJUSTMENTS
4. Inspect each of the blades for cracking, bending, deep
nicking, and wear.
If any of the blades show signs of damage or excessive
wear, remove the blades
for
a
more thorough
inspection.
ED
Removing the Blades
1. Turn the ignition switch key
OFF and remove the key
from the switch.
3. Remove the belt cover by
~
\
removing the wing nuts.
4. Raise and support the front
of the mower deck
2. Move the blade control
lever OFF
5. Remove the nut from the
spindle bolt.
L!
6. Remove the spindle bolt,
washer, blade, and spacer.
7. Repeat the procedure for the other blade(s).
Installing the Blades
1. Reinstall the blades by placing a washer, blade, and spacer
on the spindle bolt.,
2. Insert the spindle bolt up through the spindle.
3. Install the nut on the spindle bolt. Tighten to 65 - 75 ft-lb
(88 -
102
N-m) torque.
4. Repeat the procedure for the other blade(s).
5. Lower the mower deck to the ground.
6. Install the belt cover with the wing nuts.
63