ADTRAN Total Access 3000 DSLAM Installation And Maintenance Practice page 73

Ds3 primary switch module
Table of Contents

Advertisement

Table 31. ATM Provisioning Screen - MGMT Port Menu Options (Continued)
Option
Description
N/A
Maximum VCI Bits
8
Physical Address
9
Neighbor Name
10
Neighbor IP Address
11
CSM-Linecard Channel
VPI
12
CSM-Linecard Channel
VCI
13
CSM-Linecard Channel
Class
14
Suggested Linecard APS
VPI
15
Suggested Linecard APS
VCI
61181041L3-5A
Function
This field displays the maximum VCI Bits value assigned to
the port.
This option is used to set and display the Physical Address
(often the ATM address) of the management port.
This option is used to set and display the remote (far-end)
termination of the interface known as the Neighbor Name.
The Neighbor Name is an alphanumeric value up to 25
characters in length.
If the neighbor system is manageable through SNMP and
supports the object ifName, the value of this field must be
identical with that of ifName for ifEntry of the lowest level
physical interface for this port.
This option is used to set and display the Neighbor IP
Address in the format of xxx.xxx.xxx.xxx
The IP address of the neighbor system connected to the far-
end of this interface, to which a Network Management
Station can send SNMP messages, as IP datagrams sent to
UDP port 161, in order to access network management
information concerning the operation of that system.
This option is used to set and display the VPI to establish
communication between the PSM and the DS3 module.
This option is used to set and display the VCI to establish
communication between the PSM and the DS3 module.
This option is used to set and display a traffic descriptor
service category for the access module (line card) channel.
The options are as follows:
• CBR (Constant Bit Rate)
• rtVBR (real time Variable Bit Rate)
• nrtVBR (non-real time Variable Bit Rate)
• UBR (Unspecified Bit Rate)
This option is used to set and display the VPI to establish
communication between separate DS3 modules.
This option is used to set and display VCI to establish
communication between separate DS3 modules.
Menu Trees
63

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ds3-psm

Table of Contents