ADTRAN IP 700 Series Administrator's Manual page 71

IP 700 Series Phone Administrator Guide
Parameter
IntercomGroupPreference
IdleSelectOrder
Include
IPAddress
Layer2Audio
Layer2Signaling
LineSeizeFaliure
61200770E1-31C
Table 12. Configuration Parameters (Continued)
Value Type Description
0 to 11 Specifies which line (should be of GI
type) represents the intercom lines on
the phone. For key system mode, set
this to the GI configured line. It
appears on the phone as Intercoms.
0 to 4 Defines the idle and originate
preference selection order:
0=Select previous active and
connected
1=Select lowest available index
2=Select highest available index
3=Select circular form, previous active
and connected
4=No Select (incoming calls
presented on highest available)
Default: 1
Up to 64 Specifies a file name that is included
ASCII in the master configuration file. Files
Characters may be specified completely, or may
include the variable $Hardware. The
value of the Hardware Version
(programmed into flash at the factory,
e.g., K01M01P01L01) is substituted
for $Hardware when the file name is
created. This will permit parameters to
be specified based on a specific
hardware release.
N/A Specifies the IP address for the
phone.
Default: 0.0.0.0
0 to 7 Specifies outbound tagging on audio
packets.
Default: 5
0 to 7 Specifies outbound tagging on
signaling packets.
Default: 3
True or False Enables tone notification when
attempts to seize an SCA line fails
(e.g., another user seizes the call
first).
Default: True
Copyright © 2009 ADTRAN, Inc.
Appendix A. Configuration and Line Parameters
Sources
Config File
Web Interface
Config File
Web Interface
Config File
DHCP
Phone Interface
Web Interface
Config File
Config File
Web Interface
Config File
Web Interface
71