Console - Stairmaster Stratus Systems Owner's Manual

3900 RC
The Stratus 3900 RC cycle ergometer is protected by two plastic side covers.
Refer to Figure 13 for the fastener locations.
1. The side covers are held in place with six reusable fasteners. Slide
either end of the fastener removal tool under the edge of the head pin
and pull the pin out about halfway (see Figure 11). The pin should not
be pulled out of the fastener base.
2. Slide the neck grommet up the frame and away from the covers.
3. Move the crank to about the eleven o'clock position on the right side
to get the right side cover over the crank. Once the right cover is off
the frame, move the cranks to the one o'clock position on the left side
and remove the left cover.
4. To reinstall the cover fasteners, reinsert the fastener base through the
cover and into the frame. When the base is in place, push the head
pin in all the way to secure the fastener.

Console

1. Unscrew the console mounting knobs (2-3300 CE, 4-3900 RC) from
the back of the console, and disconnect the main cable connector
from the console.
2. Reverse the steps to reinstall the console.
PARTS REMOVAL AND REPLACEMENT
Page 45