Installing A Power Supply - Dell PowerEdge C6220 II Hardware Owner's Manual

Installing a Power Supply

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
CAUTION: The System requires at least one power supply to operate normally.
1 Verify that both power supplies are of the same type and have the same
maximum output power.
NOTE: The maximum output power is printed on the power supply label.
2
Slide the new power supply into the chassis until the power supply is
fully seated and the release lever snaps into place. See Figure 3-7.
3 Connect the power cable to the power supply and plug the cable into a
power outlet.
NOTE: When installing a new power supply in a system with two power supplies,
allow several seconds for the system to recognize the power supply and
determine its status.
Installing System Components | 161