Download  Print this page

Removing The Blower Module Bay; Installing The Blower Module Bay - Dell PowerEdge VRTX Owner's Manual

Enclosure.
Hide thumbs

Advertisement

Removing The Blower Module Bay

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
CAUTION: The blower closeout door is spring loaded. To prevent injury, exercise care when placing your hand or
fingers inside the blower module bay.
1.
If installed, remove the front bezel.
2.
Turn off the server modules using the operating system commands or the CMC.
3.
Turn off the enclosure, including any attached peripherals, and disconnect the enclosure from the electrical outlet
and peripherals.
4.
Remove the four blower modules.
5.
Loosen the four screws securing the blower module bay to the chassis.
6.
Pull the blower module bay out of the chassis.
Figure 51. Removing and Installing the Blower Module Bay
1.
blower module bay

Installing The Blower Module Bay

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
2.
screws (4)
75

Advertisement

Table of Contents

   Related Manuals for Dell PowerEdge VRTX

Comments to this Manuals

Symbols: 0
Latest comments: