Removing The Wheel Assembly - Dell PowerEdge VRTX Owner's Manual

Figure 28. Removing and Installing the Power Cable Retention Bracket
1. chassis slots
3. power cable retention bracket

Removing The Wheel Assembly

1. Remove any cables routed through the power cable retention bracket.
2. Slide the power cable retention bracket to the right to unlock it.
3. Holding it by the edges, pull the bracket out of the chassis slots and away from the chassis.
4. To reduce the chassis weight, remove the following (if required):
a) Front bezel (if installed)
b) Hard drives. See Removing A Hot-Swap Hard
c) Server modules. See
d) Power supplies. See
5. Lay the enclosure on a sturdy, stable surface with the cover release latch side on top, and the base of the
enclosure extending slightly off the surface edge.
6. Loosen the two screws securing the front and back wheel plates to the chassis.
7. Remove the metal stands on the front and back wheel plates from the hooks on the system base cover.
46
Drive.
Removing A Server Module.
Removing A Power Supply.
2. tabs on the power cable retention bracket (2)