Chapter 10 - Utilities; To Add A Test Code I.d. Prefix To All Symbologies; Show Decoder Revision; Show Scan Driver Revision - Honeywell Vuquest 3310g User Manual

10
Utilities

To Add a Test Code I.D. Prefix to All Symbologies

This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, beginning on page 15-1) for
the single character code that identifies each symbology.) This action first
clears all current prefixes, then programs a Code I.D. prefix for all symbologies.
This is a temporary setting that will be removed when the unit is power cycled.
Add Code I.D. Prefix to
All Symbologies (Temporary)

Show Decoder Revision

Scan the bar code below to output the decoder revision.
Show Decoder Revision

Show Scan Driver Revision

Scan the bar code below to output the scan driver revision. The scan driver
controls image capture.
Show Scan Driver Revision

Show Software Revision

Scan the bar code below to output the current software revision, unit serial num-
ber, and other product information for both the scanner and base.
Show Revision
10 - 1