®
Gilbarco
Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Gil-
barco terminal. This bar code sets the baud rate to 2400 bps and the data
format to 7 data bits, even parity, 2 stop bits. It also also adds a carriage
return (CR) suffix and programs the following prefixes for each symbology:
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on
programming code above.
Honeywell Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Honey-
well bioptic scanner auxiliary port configuration. This bar code sets the
baud rate to 38400 bps and the data format to 8 data bits, no parity, 1 stop
bit.
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on
programming code above.
Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Gilbarco Settings
Honeywell Bioptic Settings
Prefix
A
E0
FF
F
page 1-6
first, then scan the
page 1-6
first, then scan the
2 - 5