Cutting; Troubleshooting - Honda H5013 Owner's Manual

9. TROUBLESHOOTING
Poor finishing/appearance.
1. Tractor speed too fast
2. Grass accumulation
inside deck.
) Shift to lower speed.
) Clean deck underside (see
p.49)
3. Dull blade ) Have the blade sharpened or
replace it.
4. Tires improperly inflated * Check tire inflation.
5. Mower not level
* Check cutter deck mounting.
6. Wrong cutter deck height-
Change to proper height.
7. Engine speed too low
) Run at full throttle.
Blades do not rotate or stop.
1. Blade drive belt worn or
broken
) Replace with new belt (see
p.48)
2. P.T.O. lever cable faulty or - See your authorized HONDA
out of adjustment
tractor dealer.
3. Faulty P.T.O. clutch or ) See your authorized HONDA
worn disk
tractor dealer.
Clogged cutter deck discharge
chute.
1. Wrong blade
2. Deck too low
3. Engine overloaded
* Use genuine Honda blade or
equivalent.
* Raise deck and adjust deck
height properly.
) Operate at full throttle. Use
lower speed range. Set cutter
deck higher than desired
height for first pass, then cut
to desired height on second
pass.
4. Lawn wet or watered.
5. Lawn too tall
6. Engine speed too low
) Allow to dry before cutting.
) Set cutter deck higher than
desired height for first pass,
then cut to desired height on
second pass.
) Run at Full throttle.
54