Adjustment - Honda H5013 Owner's Manual

n
Cutter deck lift rod
- 1. The cutter deck lift rod can be adjusted in the same manner as for the
cutter deck plate (step-5).
After adjustment, tighten the lock nuts and lock the adjust pins
securely.
- 2. Do not adjust the cutter deck lift rod less than 367 mm (I 4.5 in.) for
the first time. If the height of the cutter deck is below 115 mm (4.5
in.) with the cutter deck lift rod being 367 mm (14.5 in.), then adjust
the height with the cutter deck lift plates.
- 3. Adjust the cutter deck lift plates if the cutter deck fails to reach the
desired height.
If it still fails to reach the desired height, then adjust the length of the
cutter deck lift rod.
H Lift link rod
Check that the distance between the end of the rod and the bottom
washer is 38 mm (1.5 in.).
To
adjust, loosen the lock nut and turn the
adjust nut. After adjustment, retighten the lock nut securely.
ROD STOPPER
DAMPER SPRING
ADJUST NUT LOCK NUT
PIN
28