Blade Belt Inspection - Honda H5013 Owner's Manual

- 8. Turn
from
the steering wheel to the extreme left. Remove the steering wheel to the extreme left. Remove
right side of tractor. right side of tractor.
\ \ \
the cutter deck
4. Blade belt inspection and replacement
- 1. Remove the cutter deck from the tractor (see page 47).
- 2. Remove the five 8 mm nuts, remove the right and left pulley covers,
and clean any grass and other foreign matter from the inside of the
covers.
- 3. Check the belt for signs of wear or cracks.
- 4. Replace the belt with a new one if the belt is worn or damaged,
replace it in the following manner: Grasp the belt midway between
pulleys A and B, pull it toward you and to your left. Remove the belt
from the pulleys starting with pulley A. Remove the belt from the
other pulleys.
PULLEY A
PULLEY B
m
If the belt is not released slowly, the idle pulley will move sud-
denly and could injure your hand. Be sure to install the right and left pulley
covers securely. Failure to install the pulley covers can cause serious per-
sonal injury.
48