Honda H5013 Owner's Manual page 36

6. OPERATIOIN
m
Never run the engine in an enclosed area. Be sure to provide
adequate ventilation. Exhaust contains poisonous carbon monoxide gas
that may cause loss of consciousness and lead to death.
1. Adjusting cutting height
m
Be sure all moving parts have stopped before adjusting cutting
height. Contacting moving parts can cause injury.
-
1. Park the tractor on a level surface and set the parking brake.
- 2. Make sure the main transmission lever is in "NEUTRAL", both the
front and rear P.T.O. levers are "OFF" and the lift lever is in the
center (Neutral) position.
-
3. Start the engine, move the hydraulic cylinder selector lever (optional
part) to "FRONT" and raise the cutter deck fully with the hydraulic
lift lever.
-
4. Turn the descent speed adjust knob fully clockwise.
-
5. Push the hydraulic lift lever toward "DOWN," to be sure that the cut-
ter deck is locked in the fully raised position. Return the lift lever to
"NEUTRAL" and then stop the engine and remove the ignition key.
-
6. Remove the lock pin and the link pin from the gauge wheel and set
the wheel for the desired cutting height.
ADJUSTMENT
-
7. Insert the link pin in the gauge wheel shaft and secure it with the lock
pin.
-
8. Repeat the adjustment procedure for the other gauge wheel.
NOTE: Both gauge wheels must be set to the same height.
34