Table of Contents
Advertisement
Installation
Connecting the Power Cord
1.
2.
WARNING!
Your DVR is now ready to operate. See
Operation.
Rev 3.01
Figure 2-16
DC 24V
Connect the DC power cord of the adapter to the DVR.
Connect the AC power cord to the adapter and then to the wall outlet.
Note
The power cord connector locks into position to prevent
accidental power loss. Be sure to slide the release away from the
socket before removing the plug.
Route power cords so they are not a tripping hazard.
Make certain the power cord will not be pinched or
abraded by furniture. Do not install power cords under
rugs or carpet.
The power cord has a grounding pin. If your power outlet
does not have a grounding pin receptacle, do not modify
the plug.
Do not overload the circuit by plugging too many devices
in to one circuit.
Power Cord Connector
Chapter 3, Configuration
16
and
Chapter 4,
Document 900.0258
10/05
Advertisement
Table of Contents
