Table of Contents
Advertisement
Solutions
Solutions
This appendix provides solutions to common technical issues.
Problem
No power
No live video
Live video extremely bright
REC LED is lit but DVR is not
recording
DVR stops recording
DVR displays an error
message that the last recorded
image date and time is later
than the current date and time
setting of the DVR
Rev 3.01
Possible Solution
•
Check power cord connections.
•
Confirm that there is power at the outlet
•
Check camera video cable and connections.
•
Check monitor video cable and connections.
•
Confirm that the camera has power
•
Check camera lens settings
If a cable is attached to the "Loop" connector, make
certain it is connected to a properly terminated
device.
Unit only records video based on the parameters
such as schedule and events defined during
configuration. Red REC LED indicates the DVR is
ready to record.
If the hard disk drive is full, you need to either delete
video or set the DVR to the Overwrite Mode.
The DVR automatically resets the time and date of the
unit, according to the time and date of the last
recorded image.
If this is not the correct time and date, reset the time
and date manually.
If the correct time and date is earlier than the last
recorded image, any video with a later time and date
will be lost when resetting the correct time and date.
97
B
Document 900.0258
10/05
Advertisement
Table of Contents
