Table of Contents
Advertisement
Configuration
5.
6.
Main Monitoring Setup Screen
Use the Main Monitoring Setup screen (MENU
adjust the display dwell time for each camera displayed on the main monitor. You can
also turn camera sequence and event monitoring on and off.
1.
2.
You can define the screen layout in a variety of formats and set the DVR to sequence
through the different screen layouts (pages) so that all the cameras will display. You can
also set up the DVR to display one camera or a group of cameras all the time while
cycling through the remaining cameras in a cameo window. This can be done with one
Rev 3.01
Highlight the box beside Left/Right Margin and then press # to adjust the left and
right margins. The margins can be set from 1 to 24.
Highlight the box beside Top/Bottom Margin and then press # to adjust the top
and bottom margins. The margins can be set from 1 to 24.
Figure 3-41
Highlight the box beside Sequence Dwell Time and then press # . You can adjust
the sequence dwell time from 3 to 60 seconds.
Highlight the box beside Sequence in Cameo and then press # to toggle
between On and Off. (Not on 4-camera model.)
Pressing SEQUENCE causes the DVR to sequence cameras, and the DVR can
sequence cameras in two modes:
Page. In Page mode, the DVR sequences through user-defined screen
layouts (pages).
Cameo. In Cameo mode, the bottom right window in a multiscreen format
sequences through all cameras.
Note
The DVR does not sequence the camera having video loss in the
Cameo mode.
Main Monitoring Setup Screen
59
Display
Main Monitoring) to
Document 900.0258
10/05
Advertisement
Table of Contents
