Figure 3-13 Storage Screen - Honeywell HRHD4+ User Manual

Configuration
The Type field displays the type and capacity of storage devices.
The Status field displays the device status or fault conditions. The choices are
described as follows:
Status
Good
Bad
S.M.A.R.T. Inop.
S.M.A.R.T. Alert
High Temperature
Not installed
The C° field displays the temperature of the storage device.
The Usage field displays the device usage.
Rev 3.01
Figure 3-13 Storage Screen
Note When the DVR has more than four storage devices, you can
scroll through the list by selecting the Up and Down arrows
under the list.
Table 3-2 Storage Screen Status Options
Description
The storage condition is normal.
Data cannot be written on or read from the storage device.
Storage conditions are normal; however, the S.M.A.R.T.
monitoring is not working or is not supported.
S.M.A.R.T. monitoring has detected a fault condition.
S.M.A.R.T. monitoring has detected that the storage device
temperature exceeded the preset temperature threshold.
The storage device is not installed.
Note After the S.M.A.R.T. Alert message displays, we recommend you
replace the hard disk drive, usually within 24 hours.
33 Document 900.0258
10/05