Advertisement
www.collegehillshonda.com
42. Secure the rear camera harness to the harness
clamp bracket B with three small wire ties. Attach
the wire tie over the tape attached to the
harness.
HARNESS
CLAMP
BRACKET B
SMALL
WIRE TIE
100 mm
43. Torque the T50 TORX bolt to 29 to 32 N·m (21 to
23 lbs).
44. Close the tailgate. Remove the lower outboard
hinge bolt, and attach harness clamp bracket A to
the tailgate hinge with the TORX bolt you just
removed. Do not tighten the TORX bolt at this
time.
TAIL GATE
T50 TORX BOLT
HINGE
(Do not tighten at this time.)
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
T50 TORX BOLT
(Torque to 29 to32 N·m)
REAR
CAMERA
HARNESS
TAPE
25 mm
SMALL
WIRE TIE
(Attach over
the tape.)
5D10020T
TAIL GATE
HARNESS
CLAMP
BRACKET A
5D10030T
45. Pull the rear camera harness out from the inside
of the tailgate, and secure the rear camera
harness to the harness clamp bracket A with one
small wire tie.
T50 TORX
BOLT
(Torque to
29 to32 N·m)
SMALL
WIRE TIE
46. Torque the T50 TORX bolt to 29 to 32 N·m (21 to
23 lbs).
47. Using isopropyl alcohol on a shop towel, clean the
tailgate where the cushion tapes will attach. Using
scissors, cut one cushion tape in half. Secure the
rear camera harness to the tailgate with two half
cushion tapes and two full cushion tapes at the
locations shown.
CUSHION TAPE
AII 36587 (0705)
130 mm
HARNESS
CLAMP
BRACKET A
REAR CAMERA
HARNESS
REAR
TAILGATE
CUSHION TAPE
(Cut in half.)
TAIL
GATE
REAR
CAMERA
HARNESS
5D10041T
4N09050K
13 of 17
Advertisement
