Table of Contents
Advertisement
Quick Links
INSTRUCTIONS
PARTS LIST
Right front damper assembly
Left front damper assembly
2 Rear dampers
2 Rear springs
4 Flange bolts, 14 x 57 mm
© 2010 American Honda Motor Co., Inc. - All Rights Reserved.
Accessory
SPORT SUSPENSION
P/N 08W60-SVA-100
4 Flange bolts, 12 x 54 mm
2 Flange bolts, 12 x 98 mm
2 Flange bolts, 12 x 65 mm
4 Self-locking nuts, 14 mm
2 Self-locking nuts, 12 mm
2 Self-locking nuts, 10 mm
Important information
AII 44382 (1008)
Application
2011 CIVIC
2-DOOR (LX, EX)
Publications No.
AII 44382
Issue Date
AUG 2010
1 of 9
08W60-SVA-1000-91
Advertisement
Table of Contents
Related Manuals for Honda 08W60-SVA-100
Summary of Contents for Honda 08W60-SVA-100
-
Page 1: Installation Instructions
2 Self-locking nuts, 12 mm 2 Self-locking nuts, 10 mm 2 Rear springs Important information 4 Flange bolts, 14 x 57 mm 1 of 9 © 2010 American Honda Motor Co., Inc. - All Rights Reserved. AII 44382 (1008) 08W60-SVA-1000-91... - Page 2 This may allow the inner installing the right damper assembly. CV joint bearing to unseat. DAMPER PINCH BOLTS SELF- LOCKING NUTS 2 of 9 AII 44382 (1008) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.
- Page 3 Remove the three flange nuts from the top of the damper. SERVICE Remove the damper assembly. Be careful not to FLANGE NUTS damage the body. DAMPER ASSEMBLY 3 of 9 © 2010 American Honda Motor Co., Inc. - All Rights Reserved. AII 44382 (1008)
- Page 4 13. Repeat steps 2 thru 11 to install the right front damper. 14. Reinstall the service cap and the lid. 15. Reinstall the front wheels. 4 of 9 AII 44382 (1008) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.
- Page 5 20. Remove the brake hose mounting bracket. TRIM PANEL SEAT-BACK RELEASE CABLE SLIT • Remove the trunk right side trim panel the same way. 5 of 9 © 2010 American Honda Motor Co., Inc. - All Rights Reserved. AII 44382 (1008)
- Page 6 22. Remove the flange bolt that connects the knuckle damper shaft with a hex wrench. and the upper arm. SELF- LOCKING FLANGE BOLT WRENCH DAMPER SHAFT UPPER KNUCKLE 6 of 9 AII 44382 (1008) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.
- Page 7 SPRING MOUNTING RUBBER SPRING SPRING LOWER SPRING SEAT LOWER SPRING SEAT TRAILING 7 of 9 © 2010 American Honda Motor Co., Inc. - All Rights Reserved. AII 44382 (1008)
- Page 8 TRAILING FLANGE JOINT PIN 34. Install the stabilizer link on the trailing arm with a new self-locking nut, and lightly tighten both nuts. 8 of 9 AII 44382 (1008) © 2010 American Honda Motor Co., Inc. - All Rights Reserved.
- Page 9 9.8 N·m (7.2 lb-ft). 45. Reinstall the wheels, and torque the wheel nuts to 108 N·m (80 lb-ft). 9 of 9 © 2010 American Honda Motor Co., Inc. - All Rights Reserved. AII 44382 (1008)