Advertisement
32. Drill three 8 mm holes and one 10 mm hole in the
tailgate.
•
Wrap tape around a 3 mm drill bit, and 8 mm
drill bit and a 10 mm drill bit 10 to 15 mm from
the end or use a drill stop.
•
While wearing eye protection, drill a 3 mm
hole, then an 8 mm hole in all four locations.
Drill a 10 mm hole only in the upper center
hole.
•
Remove any burrs, and apply touch-up paint
to all of the holes.
DRILL BIT
10 ~ 15 mm
DRILL BIT
(3 mm
8 mm
10 mm)
DRILL
33. Install one blind nut into each 8 mm hole.
BLIND
NUTS
10 of 17
www.collegehillshonda.com
TAPE
(Wrap tape around
UPPER
the drill bit.)
CENTER
HOLE
TAILGATE
4 MARKS
4708021K
DRILL BIT
(3 mm
8 mm)
TAILGATE
3 8 mm
4708030K
HOLES
34. Remove the four screws from the rear camera.
Route the rear camera harness through the rear
camera subbracket, and install the rear camera
subbracket to the rear camera with the four
screws.
REAR CAMERA
HARNESS
35. Attach a piece of wire to the terminals from the
rear camera harness, and tape the wire to the
terminals.
TERMINALS
TAPE
AII 36587 (0705)
REAR
CAMERA
REAR CAMERA
SUBBRACKET
4 SCREWS
REAR CAMERA
HARNESS
WIRE
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
4708050K
4913020K
Advertisement
