Multi Picture Function; Split Mode - Hitachi Ultravision C50-LD7000 Instruction Manual

MULTI PICTURE FUNCTION

The Multi Picture function on this projection TV provides two modes, Split and P in P. To use the Multi
Picture function allows you to enjoy the programs conveniently and comfortably.
In normal picture mode, press the MULTI PIC. button to enter Split or P in P mode.

Split mode

Follow the steps on page 20, enter menu and then
Function menu to select Multi Picture option as shown on
right.
Press the cursor buttons to set Multi picture
option to Split mode and then quit the menu.
In normal TV mode, press the MULTI PIC. button to
enter Split mode as shown below. A and B pictures will
show two programs of two channels respectively.
Once you have entered Split mode, press the A/B button
to select any one of the two pictures. A red trumpet symbol will appear on top of the selected picture to
indicate as follows:
1 The speaker on this set outputs the sound from the
selected picture.
2 MONITOR OUT jack outputs audio/video signals
from the selected picture.
(3) VARIABLE AUDIO OUT jack output audio
signal from the selected picture.
4 The operations such as program selection, etc. are
valid for the selected picture. However, the
program No. selected in one picture can not be the
same as that in the other one. Otherwise, the "! Not
Available" symbol will appear.
Notes:
When the RECALL button is pressed, A and B pictures will display their respective programs No. instantly,
and the red trumpet symbol will appear on top of the selected picture momentarily.
While in Split mode, press the SWAP button to switch between the two pictures, namely, the exchange
of program sources in A, B pictures.
If Freeze option in Function menu is set to Still, while in the normal TV mode, pressing the FREEZE
button will enter Split mode automatically. A picture will display the current moving picture and B picture
will display a still picture frozen by pressing the FREEZE button. On this point MONITOR OUT terminal
on this set output video/audio signals from A picture, VARIABLE AUDIO OUT terminal output audio
signal from A picture too. Set Freeze option in Function menu to Strobe, please see page 36 in detail.
In Split mode, the POSITION button will be invalid.
In Split mode, press the MULTI PIC. or RETURN button to quit. If you enter the menu by pressing the
MENU button, it will exit the Split mode.
A B
32
Split