Table of Contents
Advertisement
BEFORE OPERATION
To connect the power cord and the antenna
Please read the rating label pasted at the back of the TV set carefully, and then insert the plug into the power outlet conformity to the
rating label. Better reception requires that an outdoor aerial or CATV system must be used. Meanwhile, please note that a good
antenna adaptor is necessary. See the following diagram.
Precautions when connecting the antenna
If you use an outdoor antenna instead of CATV system, be sure the antenna shouldn't be located in the vicinity of
overhead power lines or other electrical circuit.
If you use an outdoor antenna, be sure the antenna system is grounded properly.
Please use a coaxial cable that is free from interference. Avoid using a parallel feeder wire as interference may often
occur, causing reception to be unstable and stripe noise to appear on the screen. For safety, install an external aerial
conformity to AS 1417.1(in Australia only).
Clamp section A using pliers when installing the coaxial cable. If other types of adaptors are used, be sure that the core
and shielding are good.
Avoid using indoor aerial as this may be affected by interference.
Keep the power cord as far away from the antenna wire as possible.
To prepare the remote control unit
Insert the batteries into the remote control unit. Under normal use, the life of the batteries is approximately one year.
Open the battery cover of the remote control
unit by pushing the notched part of the cover
with your fingers.
Precautions when using the batteries
Don't use old and new batteries together.
Don't use different types of batteries (e.g. Manganese and Alkaline batteries) together.
Remove the batteries from the remote control unit if you don't intend to use the unit for a long time. Otherwise the
batteries may leak.
Don't throw the batteries into a fire.
Precautions when using the remote control unit
Don't drop the remote control unit or subject it to physical shocks.
Keep the remote control unit dry. Wetting it may cause the unit to malfunction.
Replace the batteries with new ones when operation range of the unit shortened.
Insert the batteries, paying special
attention to their polarities.
8
Replace the cover.
Advertisement
Table of Contents
