Table of Contents
Advertisement
LAMP REPLACMENT
6.
Without installing the lamp cover, the power will be off and the lamp Indicator will flash. Be sure to install the lamp cover by
re-engaging the two clips and tighten the screws before turning the power on, otherwise it may cause unusual colors.
SCREW DRIVER
NOTE IF POWER IS CONNECTED BEFORE THE LAMP COVER IS INSTALLED, THE POWER
WILL BE OFF AND THE LAMP INDICATOR WILL FLASH.
I
7.
nstall the front cover as show below. Put the front cover back in and align the snap on quick connect then push inwards
holding the left and right side of the front cover until you hear a snap. Push the other snap on gently to make a good fit.
FRONT COVER
8.
Plug power cord into AC outlet and turn on the main power switch.
NOTE The lamp in this product contains Mercury. Obey local ordinances when disposing of used
lamps. In most case, it is possible to dispose of used bulbs in the same manner as used
glass bottles, but in some cases, bulbs are sorted separately.
SCREW
LAMP COVER
PUSH
POWER ON/OFF SWITCH
53
Advertisement
Table of Contents
