Hitachi Ultravision C50-LD7000 Instruction Manual page 25

Lcd rear projection color tv
Table of Contents

Advertisement

ON-SCREEN DISPLAY MENU SETUP MENU
10
If the noise in the picture are bigger resulted from the
weaker RF signals from some channels, you can
reduce such occurrence by using TV NR function.
Press the
cursor buttons to select TV NR option
and then press the
Low and High these three options for turning off noise
reduction function, low noise reduction range and
high noise reduction range.
Different channels can set independently.
Note: This option is valid only for RF signal from
antenna
11
All Programs in Tuning menu can automatically
search all available frequencies and store all stations
available to the program numbers starting from the
current program No.
Press the
cursor buttons to select Program
Number option and then press the
buttons or number button to select program No.
Press the
cursor buttons to highlight All Program
option as shown on right. Then press the ENTER
cursor button to begin the auto tune procedure. The
letter Searching appears at the bottom of the menu and the TV will be now searching all frequencies and
store all stations to the program numbers starting from the Program Number selected.
In the process of searching , you can press the ENTER button to quit.
When completing searching, the TV will quit the menu automatically.
AV Preset
Press the TV/VIDEO button to switch the picture to
the AV mode.
Then select the Preset menu (follow the steps before)
to display the menu on right. Press the
buttons to select AV Mode option and
TV/VIDEO to select AV1, AV2, AV3, AV4 or AV5.
Press the
cursor buttons to select Color System
option, then press the
AUTO, PAL, SECAM, NTSC4.43 or NTSC3.58.
If the picture in AV mode is abnormal resulted from
incorrect color system, you can use Color System
option to select the correct system.
When receiving component signal (Y, P
change though Color System option above are changeable. This is normal.
cursor buttons to select Off,
cursor
or
cursor buttons to select
/C
, P
B
B
cursor
/C
) from INPUT1 or INPUT2 terminal, the picture will not
R
R
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ultravision c60-ld7000

Table of Contents