Tv Scan Function; 3-Picture Mode - Hitachi Ultravision C50-LD7000 Instruction Manual

TV SCAN FUNCTION

The TV Scan function on this projection TV provides two modes, 3-picture and 12-picture. To use the
TV Scan Function allows you to enjoy the programs conveniently and comfortably.
While in a normal TV mode, press the TV SCAN button to enter 3-picture or 12-picture.

3-picture mode

Follow the steps on page 20 to enter menu and then
Function menu to select TV Scan option as shown on right.
Press the cursor buttons to set TV Scan to mode
3 and then quit the menu.
While in a normal TV picture mode, press the TV SCAN
button to enter 3-picture mode as shown below.
A picture will display the current moving picture.
The speaker, rear VARIABLE AUDIO OUT terminal
output the sound from A picture. The MONITOR OUT
terminal output audio/video signals from A picture.
B1, B2, B3 will display all the unset skipping program
numbers starting from program No.0 in sequence every
several seconds.
While in this mode, press the program up/down
buttons or program number buttons to select A picture. As to
B group B1, B2, B3 picture, press the
to select any one of the pictures among B1, B2 or B3
pictures. The color of program No. in the highlighted picture
will change from white to green. At this point, press the
ENTER button, the picture selected in B group will be
switched to A picture.
While in this mode, press the TV SCAN or RETURN button to quit. If you enter the menu by pressing the
MENU button, it will exit 3-picture mode.
In 3-picture mode, the A/B, SWAP and POSITION buttons are invalid.
Note: Not all signal inputs are valid for 3-picture mode. Even if the signal may be displayed in TV mode before
entering 3-picture mode, it may not be displayed while in 3-picture mode. In this case, the hints will appear in
pictures where the signal are not available, namely, the "! Invalid Signal" symbol will appear in A picture, or the
"!" symbol will appear in B picture. This is normal.
P- buttons
P+
35
A
B1
B2
B3