Hitachi Ultravision C50-LD7000 Instruction Manual page 41

OTHER FUNCTIONS
To switch aspect mode, please press the P.SIZE button when the word showing the corresponding aspect
mode will appear momentarily at the lower part of the screen. For example, set the current aspect mode to
as shown at the lower left side. If
16:9
press the cursor buttons to adjust the display position up and down before the words
" 16 : 9Zoom +3
in 4:3Zoom1 , 4:3Zoom2 or Expanded mode.
Press the P.SIZE button, the aspect mode will be reserved in
4:3Zoom1 or 4:3Zoom2 mode after completing the program selection or restarting the TV.
When HD component signal is inputted:
Press the P.SIZE button to switch between two different modes including
The aspect mode will return to the mode of
TV.
Please see the following for details on each of two modes.
Suggested
aspect
mode
16 : 9Zoom
Notes
1. In multi picture, pressing the P.SIZE button is not available.
2. Please note, do not watch TV at non full screen size for a long time, this may cause remain picture.
3. Using this special function (aspect mode) to change the size of image displayed for purpose of public
release or some commercial interests (i.e., change the ratio of height and width), this may infringe the
law of copyright.
Scroll" disappear as shown at the lower right side. Likewise, the function is available
16 : 9
is set as shown at the lower right side, you can
16:9 Zoom
16:9 , 16:9Zoom , 4:3 ,
after completing the program selection or restarting the
16:9
Signal sources
HD Signal
41
Expanded
16:9 , 16:9Zoom .
HD Signal