Hitachi Ultravision C50-LD7000 Instruction Manual page 34

MULTI PICTURE FUNCTION
Once you have entered P in P mode, press the A/B button to select any one of the two pictures. A red
trumpet symbol will appear on the selected picture to indicate as follows.
1 The speaker on this set outputs the sound from the selected picture.
2 MONITOR OUT jack output audio/video signals from the selected picture.
3 VARABLE AUDIO OUT jack output audio signal from the selected picture.
4 The operations such as program selection etc. are valid for the selected picture. However, the program
No. selected in one picture can not be the same as that in the other one. Otherwise, the "! Not Available"
symbol will appear.
Notes:
When the RECALL button is pressed, A and B pictures will display their respective programs No. instantly,
and the red trumpet symbol will appear on top of the selected picture momentarily.
Press the POSITION button to move B picture to each corner on the screen in sequence as shown above.
Don't fix the B picture on a particular corner of the screen for a long time.
In P in P mode, press the MULTI PIC. or RETURN button to quit. If you enter the menu by pressing the
MENU button, it will exit the P in P mode.
Notes:
Not all signal inputs are valid for P in P mode. Even if the signal may be displayed in TV mode before
entering in P in P mode, it may not be displayed while in P in P mode. In this case, the hints will appear in
picture where the signal are not available, namely, the "! Invalid Signal" symbol will appear in A picture, or the
"!" symbol will appear in B picture. This is normal.
34