P In P Mode - Hitachi Ultravision C50-LD7000 Instruction Manual

MULTI PICTURE FUNCTION

P in P mode

As indicated before (20 page) , entering menu to display
the Function menu and then select the P in P option as
shown on right.
Press the cursor buttons to set the Multi Picture
option to P in P mode and then quit the menu.
In normal TV mode, press the MULTI PIC. button to
enter the P in P mode.
P in P will be various according to different signal
format.
(1) While both the main picture and sub picture are RF
or video or 525i component or 625i component signal, the display is in P out P mode as shown below.
Notes: When entering this mode, press the SWAP button to switch between the two pictures, namely, the
exchange of program sources of A, B pictures.
.
(2) While the main picture is receiving HD signal of 1125i format, the sub picture receiving RF or video or 525i
component or 625i component signal, the display is in P in P mode as shown below.
Note: When entering this mode, press the SWAP button to switch to P out P mode. At one time, B picture won't
display normally and the "!" will appear in B picture. This is normal.
A
A
33
B
B