Table of Contents
Advertisement
Installation
Mounting the outer door
1. Unscrew the screws on the mount plate. Lift the
plate off together with the door.
2. Lay the machine down on its back. Check that
none of the hoses are trapped. Insert the guide
rods into the plastic door guides.
3. Slot the tabs on the mount plate into the holes
on the front plinth of the machine and screw
the mount plate into place using the 2 screws
provided.
Fitting protective and cap strips
In order to fill the gap between the cupboard and the dish-
washer and to protect the cupboard above from any steam
that comes out of the washer, a self-adhesive protective
strip is attached along the upper edge of the cupboard
and two gap strips are attached along the edge of the
cupboard.
1. Clean all surfaces where the strips are to be
attached to ensure better adhesion.
2. Attach the protective strip along the upper edge
of the cupboard. If it is too long, it can easily be
cut to the right length.
3. Attach the two gap strips along each side of the
cupboard, level with the front edge of the sides.
Mounting the dishwasher
1. Put the dishwasher into the cupboard and screw
the mount plate into position from underneath
with 2 screws, with the washers between.
2. Put the spacers provided at the sides of the
machine and screw the machine into place in
the cupboard.
Check that there is a space between the cupboard
frame and the wooden door when it is shut.
Tab
- 18 -
Advertisement
Table of Contents
