Table of Contents
Advertisement
Installation
Preparing the outer door
Screw the guide rods and hinges on the door into place
using the predrilled holes.
Mount plate
Before installing the dishwasher and adjusting the door
onto the cupboard, put the mount plate into its correct
position on the shelf.
1. Place the mount plate in the middle of the cup-
board. Mark the holes for screws and the holes
for dismounting the outer door. There is a middle
mark on the plate to help you.
2. Drill 4 holes with a diameter of 7 mm. The door
can be disconnected if necessary, through hole
1 (two holes).
3. Then screw the plate into place from under-
neath using the 2 screws provided, with the
washers between.
4. Snap the hinges into the brackets on the mount
plate.
The outer door should be supported under-
neath in order to prevent the hinges from
breaking off.
5. Adjust the door to surrounding doors using
screws A, B and C.
A B
C
C
- 18 -
2x
4x
1
1
Hide quick links:
Advertisement
Table of Contents
