Electrolux ESL67040R User Manual

Electrolux ESL67040R User Manual

Reallife® fully integrated dishwasher

Advertisement

user manual
Dishwasher
ESL 67040

Advertisement

Table of Contents
loading

Summary of Contents for Electrolux ESL67040R

  • Page 1 user manual Dishwasher ESL 67040...
  • Page 2: Table Of Contents

    2 electrolux Share more of our thinking at www.electrolux.com CONTENTS Safety information Product description Control panel Use of the appliance Setting the water softener Use of dishwasher salt Use of detergent and rinse aid Multitab function SAFETY INFORMATION Before the installation and use, read this manual carefully: •...
  • Page 3 – If the water inlet hose or the safety valve are damaged, immediately dis- connect the mains plug from the mains socket. – Contact the service centre to replace the water inlet hose with safety valve. Warning! Dangerous voltage. electrolux 3...
  • Page 4 4 electrolux Electrical connection • The appliance must be earthed. • Make sure that the electrical information on the rating plate agrees with the power supply. • Always use a correctly installed shock- proof socket. • Do not use multiple plugs and extension cables.
  • Page 5: Product Description

    • When the appliance has a malfunction, a red visual signal flashes on the floor be- low the appliance door. If the appliance is installed in height, with a flush kitchen furniture door, the visual signal does not show. electrolux 5...
  • Page 6 6 electrolux On/off button Display Delay start button Programme button (down) Programme button (up) Energy saver button Multitab button Reset button Indicators Salt indicator. It comes on when it is necessary to fill the salt container. After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance.
  • Page 7: Use Of The Appliance

    (refer to 'Multitab func- tion'). Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. electrolux 7...
  • Page 8: Use Of Dishwasher Salt

    8 electrolux Water hardness German degrees French degrees (°dH) (TH°) 51 - 70 91 - 125 43 - 50 76 - 90 37 - 42 65 - 75 29 - 36 51 - 64 23 - 28 40 - 50...
  • Page 9: Use Of Detergent And Rinse Aid

    4. Close the rinse aid dispenser. Press the lid until it locks into position. Adjust the rinse aid dosage Factory set: position 3. electrolux 9 to open the of the rinse aid dispenser. with rinse...
  • Page 10: Multitab Function

    10 electrolux You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). MULTITAB FUNCTION The multitab function is for combi detergent tablets. These tablets contain agents as detergent, rinse aid and dishwasher salt. Some types of tablets can contain other agents.
  • Page 11: Setting And Starting A Washing Programme

    • First remove the items from the lower basket, then from the upper basket. • There can be water on the sides and on the door of the appliance. Stainless steel becomes cool more quickly than the dishes. electrolux 11...
  • Page 12: Washing Programmes

    12 electrolux WASHING PROGRAMMES Programme Type of soil Heavy soil Fresh soil Normal soil Light soil Normal or light soil Use this programme to quick- ly rinse the dishes. This pre- vents the remaining food to bond on the dishes and bad odours to come out from the appliance.
  • Page 13: Care And Cleaning

    6. Fully clean the filter (B) with water. 7. Put the filter (B) to its initial position. Make sure that it assembles correctly in the two guides (C). electrolux 13 Water (litre) 9 - 11 10 - 11 11 - 12...
  • Page 14: What To Do If

    14 electrolux 8. Put the filter (A) into position in filter (B). Turn the filter (A) clockwise until it locks. WHAT TO DO IF… The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (re- fer to the table).
  • Page 15: The Washing Results And Drying Results Are Not Satisfactory

    The detergent can be the cause. The washing programme was without a drying phase or with a decreased drying phase. electrolux 15 Possible solution Replace the fuse. • Cancel the delay start. • When the countdown is completed, the washing pro- gramme starts automatically.
  • Page 16: Technical Data

    16 electrolux Problem The dishes are wet and matt. Activating the rinse aid dispenser 1. Activate the appliance. 2. Make sure that the appliance is in set- ting mode. 3. Press and hold buttons (4) and (5) at the same time until the indicators of buttons (3), (4) and (5) flash.
  • Page 17 17...
  • Page 18 18 electrolux...
  • Page 19 19...
  • Page 20 117933330-A-492010...

This manual is also suitable for:

Esl 67040

Table of Contents