Table of Contents
Advertisement
Installation
Water inlet
The dishwasher is equipped with safety features
which are to prevent the water from going back
to the fresh water system. These features are ac-
cording to current water technical safety regulations.
The temperature of the water supply should not exceed
65° C and the pressure should be between 80-1000 kPa
(0,8 - 10 bar).
It is important to have a tap or stopcock, positioned close
to the dishwasher and with easy access. Special mixer
taps with dishwasher connections are available, as well
as adaptors for older mixer taps. Connect the inlet hose
to a tap with a 3/4" pipe thread. If necessary, use the
restrictor (1/2") supplied.
The inlet hose must not be joined onto any form of exten-
sion hose. If it is too short, the entire hose must be repla-
ced with a longer high-pressure hose, specially designed
for the purpose. The end of the hose, which is connected
to the dishwasher can be turned in any direction. Loosen
the retaining nut, turn the hose, then retighten the nut.
Check that the nut and all other connections are
tight before the machine is moved into position.
Use only the inlet hose supplied to the dishwasher,
do not reuse the old inlet hose.
Water drainage
To protect the dishwasher against water damage
it is equipped with a water safety system. In the
event of a fault the drain-pump starts automatically
and the remaining water inside the dishwasher is
pumped out.
The water safety system also works when the
dishwasher is switched off. However the dish-
washer must be connected electrically.
The discharge hose must not at any point be higher up
than 75 cm over the surface which the dishwasher is
standing on. If it runs higher, operation of the dishwasher
might be impaired. The hose should always be routed at
the level which the dishwasher is standing on, rising up
only where it meets the waste pipe.
It is also important to ensure that the inside diameter of the
hose is not less than 13 mm at any point.
Electrical connection
The dishwasher is supplied with a lead and electrical plug
for connection to a 230 V earthed wall socket, which should
be easily accessible and protected by a 10 A fuse.
Before any work is carried out on the dishwasher,
it must be isolated from the electric mains supply,
for example by removing the plug from the wall
socket.
Permanent electrical installation must be carried
out by an authorized electrician.
- 19 -
Advertisement
Table of Contents
