Input Signals - Dalsa Spyder2 S2-1-40 Series User Manual

14
Table 3: DALSA Camera Control Configuration
Signal
CC1
CC2
CC3
CC4
See Appendix B for the complete DALSA Camera Link configuration table, and refer to
the DALSA Web site, vfm.dalsa.com, for the official Camera Link documents.
Digital Data
The camera digitizes internally to 10 bits and outputs either all 10 bits or the most
significant 8 bits in LVDS format on the Camera Link connector.
Note:
when outputting 10 bits with flat-field correction enabled (i.e. you will experience
missing codes).
Data Clocking Signals
These signals indicate when data is valid, allowing you to clock the data from the camera
to your acquisition system. These signals are part of the Camera Link configuration and
you should refer to the DALSA Camera Link Implementation Road Map, available at ,
http://vfm.dalsa.com/docs/appnotes/00450-00_03-
32_DALSA_Camera_Link_Road_Map.pdf, for the standard location of these signals:
Clocking Signal
LVAL (high)
DVAL (high)
STROBE (rising edge)
IMPORTANT:
See Appendix A for the complete Camera Link timing, DALSA Camera Link
configuration table, and refer to the DALSA Web site,
http://vfm.dalsa.com/docs/appnotes/00450-00_03-
32_DALSA_Camera_Link_Road_Map.pdf, for the official Camera Link document.

Input Signals

The camera accepts control inputs through the Camera Link MDR26F connector.
are optional. The camera ships in exposure mode 2 (programmable line rate and exposure time).
All Camera Control (CCx) signals are in a logic HIGH state.
the serial interface. Power-on rate is always 9600 baud. Data rate is always 40MHz. The
external control signals, EXSYNC and PRIN, are optional and enabled through the serial
interface.
PRIN
PRIN is an optional input signal used for exposure control (PRIN).
03-32-10091-04
Configuration
EXSYNC
PRIN
Spare
Spare
Due to flat-field correction calculations, certain digital numbers will be unavailable
Indicates
Outputting valid line
Valid data
Valid data
This camera's data should be sampled on the
Pin
9, 22
10, 23
11, 24
12, 25
rising edge of STROBE.
Line rate can be set internally using
Spyder2 User's Manual
All inputs
DALSA