Rear Terminal - Christie LW555 User Manual

INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in the front and top
(pp.10, 15).
LAN CONNECTION TERMINAL
Connect the LAN cable (refer to the owner's manual of "Network
Set-up and Operation").
CONTROL PORT CONNECTOR
When controlling the projector with RS-232C, connect the
control equipment to this connector with the serial control cable.
(p.19)
ANALOG OUT TERMINAL
This terminal can be used to output the incoming analog RGB
signal from INPUT 1-3 terminal to the other monitor (pp.19-20).
COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output signal to this
terminal (pp.19-20).
AUDIO OUTPUT JACK (VARIABLE)
This jack outputs the audio signal from computer or video or
HDMI equipment to external audio equipment (p.21).
R/C JACK
When using the wired remote control, connect the wired remote
control to this jack with a remote control cable (not supplied)
(p.15).
HDMI TERMINAL
Connect the HDMI signal (including sound signal) from video
equipment or the DVI signal from computer to this terminal (pp.19,
20).
is registered trademarks of HDMI
Licensing, LLC.
Kensington Security Slot
This slot is for a Kensington lock used to deter
theft of the projector.
*Kensington is a registered trademark of ACCO Brands
Corporation.
LW555 User Manual
020-000249-01 Rev.1 (05-2010)

Rear Terminal

5 BNC INPUT JACKS
Connect the component or composite video
output signal from video equipment to VIDEO/
Y, Pb/Cb, and Pr/Cr jacks or connect the
computer output signal (5 BNC Type [Green,
Blue, Red, Horiz. Sync, and Vert. Sync.]) to G,
B, R, H/V, and V jacks (pp.19-20).
S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.20).
VIDEO INPUT JACK
Connect the component or the composite video
output signal from video equipment to these
jacks (p.20).
AUDIO 3 JACKS (L(MONO)/R)
Connect the audio output signal from video
equipment connected to
For a monaural audio signal (a single audio
jack), connect it to the L (MONO) jack (p.21).
AUDIO 1 JACK
Connect the audio output (stereo) signal from a
computer or video equipment (p.21).
AUDIO 2 JACK
Connect the audio output (stereo) signal from a
computer or video equipment (p.21).
USB CONNECTOR (Series B)
Use this connector when controlling a computer
with the remote control of the projector. Connect
the USB terminal of your computer to this
connector with a USB cable (p.19).
Part Names and Functions
or to this jack.
11