Rear Terminal - Christie LWU505 User Manual

INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in the
front and top (pp.10, 15).
LAN CONNECTION TERMINAL
Connect the LAN cable (refer to the user manual of
"Network Set-up and Operation").
ANALOG OUT TERMINAL
This terminal can be used to output the incoming
analog RGB signal from INPUT 1-3 terminal to the
other monitor (pp.19-20).
ANALOG (COMPUTER INPUT TERMINAL)
Connect the computer (or RGB scart) output signal
to this terminal (pp.19-20).
AUDIO OUTPUT JACK (VARIABLE)
This jack outputs the audio signal from computer,
video, HDMI equipment or 5 BNC INPUT jacks to
external audio equipment (p.21).
R/C JACK
When using the wired remote control, connect
the wired remote control to this jack with a remote
control cable (not supplied) (p.15).
HDMI TERMINAL
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from
computer to this terminal (pp.19, 20).
is registered trademarks of HDMI Licensing, LLC.
DIGITAL (DVI-D) TERMINAL
Connect the computer output digital signal to this
terminal. The HDTV (HDCP compatible) signal can
also be connected (pp.19-20).
Kensington Security Slot
This slot is for a Kensington lock used to deter
theft of the projector.
*Kensington is a registered trademark of ACCO
Brands Corporation.
LWU505 User Manual
020-000374-01 Rev.1 (01-2011)
Part Names and Functions

Rear Terminal

5 BNC INPUT JACKS
Connect the component or composite
video output signal from video equipment
to VIDEO/Y, and Pr/Cr.jacks or connect the
computer output signal(5 BNC Type [Green,
Blue, Red, Horiz. Sync, and Vert. Sync.]) to
G, B, R, H/V, and V jacks (pp.19-20).
S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from
video equipment to this jack (p.20).
VIDEO INPUT JACK
Connect the component or the composite
video output signal from video equipment to
these jacks (p.20).
AUDIO 3 JACKS (L(MONO)/R)
Connect the audio output (stereo) signal
from video equipment connected to INPUT
3 jacks (p.21). For a monaural audio signal
(a single audio jack), connect it to the L
(MONO) jack.
AUDIO 1 JACK
Connect the audio output (stereo) signal
from a computer connected to INPUT 1
terminals. (p.21)
AUDIO 2 JACK
Connect the audio output (stereo) signal
from 5 BNC INPUT jacks (INPUT 2 jacks).
(p.21)
CONTROL PORT CONNECTOR
When controlling the projector with RS-232C,
connect the control equipment to this
connector with the serial control cable (p.19).
USB CONNECTOR (Series B)
Use this connector when controlling a
computer with the remote control of the
projector. Connect the USB terminal of
your computer to this connector with a USB
cable (p.19).
11