Rear Terminal - Christie LX505 Quick Reference Manualninja250L

Rear Terminal

①
① INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located
in the front and top.
② LAN CONNECTION TERMINAL
Connect the LAN cable (refer to the owner's
manual of "Network Set-up and Operation").
③ CONTROL PORT CONNECTOR
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
④ ANALOG OUT TERMINAL
This terminal can be used to output the
incoming analog RGB signal from INPUT 1-3
terminal to the other monitor.
⑤ COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output
signal to this terminal.
⑥ AUDIO OUTPUT JACK (VARIABLE)
This jack outputs the audio signal from
computer or video equipment to external
audio equipment.
⑦ R/C JACK
When using the wired remote control,
connect the wired remote control to this jack
with a remote control cable (not supplied).
⑧ COMPUTER INPUT TERMINAL (DIGITAL)
Connect the computer output digital signal to
this terminal. The HDTV (HDCP compatible)
signal can also be connected.
Kensington Security Slot
This slot is for a Kensington lock used to deter
theft of the projector.
* Kensington is a registered trademark of
ACCO Brands Corporation.
Downloaded From projector-manual.com Christie Manuals
Setup Guide
020-000540-01 Rev. 1 (11-2010)
③
②
⑨
④ ⑤ ⑥
⑪ ⑫
⑩
⑨ 5 BNC INPUT JACKS
Connect the component or composite video
output signal from video equipment to VIDEO/Y,
Pb/Cb, and Pr/Cr jacks or connect the computer
output signal (5 BNC Type [Green, Blue, Red,
Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V,
and V jacks.
⑩ S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack.
⑪ VIDEO INPUT JACK
Connect the component or the composite video
output signal from video equipment to these
jacks.
⑫ AUDIO 3 JACKS (L(MONO)/R)
Connect the audio output signal from video
equipment connected to ⑩ or ⑪ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack.
⑬ AUDIO 1 JACK
Connect the audio output (stereo) signal from a
computer or video equipment.
⑭ AUDIO 2 JACK
Connect the audio output (stereo) signal from a
computer or video equipment.
⑮ USB CONNECTOR (Series B)
Use this connector when controlling a computer
with the remote control of the projector. Connect
the USB terminal of your computer to this
connector with the supplied USB cable.
9
⑦ ⑧
⑬ ⑭ ⑮
LX505/605