Table of Contents
Advertisement
2 - CONNECT <text> result code returned, dial tone detection is enabled, busy
detection is disabled.
3 - CONNECT <text> result code returned, dial tone detection is disabled, busy
detection is enabled.
4 - CONNECT <text> result code returned, dial tone and busy detection are both
enabled.
Set CONNECT result code format:
AT\V
0 - CONNECT <text> result code returned without RLP trailer.
1 - CONNECT <text> result code returned with RLP trailer.
Sets all current parameters to the user profile stored with AT&W. If a
ATZ
connection is in progress, it will be terminated.
Sets phone functionality:
AT+CFUN=0 NON-CYCLIC SLEEP mode
AT+CFUN=1 Full functionality
AT+CFUN=7 CYCLIC SLEEP mode, In this mode, the serial interface is shortly
enabled while CTS is active. If characters are recognized on the serial interface,
the ME stays active for 2 seconds after the last character was sent or received.
ME exits SLEEP mode only, if AT+CFUN=1 is entered.
AT+CFUN
AT+CFUN=9 CYCLIC SLEEP mode, In this mode, the serial interface is shortly
enabled while CTS is active. If characters are recognized on the serial interface,
the ME stays active after the last character was sent or received for at least the
time, which can be configured by
AT^SCFG="PowerSaver/Mode9/Timeout",<psm9to> (temporary wakeup). In
contrast to SLEEP mode 7 assertion of RTS can also be used to temporarily wake
up the ME.
AT^SMSO
Initiates the power-off procedure.
AT+GCAP
Request complete TA capabilities list.
Mobile Equipment Error Message Format:
AT+CMEE=0 Disable result code, i.e. only "ERROR" will be displayed.
AT+CMEE
AT+CMEE=1 Enable error result code with numeric values.
AT+CMEE=2 Enable error result code with verbose (string) values.
Select TE character set:
AT+CSCS="GSM" GSM default alphabet (GSM 03.38 subclause 6.2.1); Note:
This setting may cause software flow control problems since the codes used to
stop and resume data flow (XOFF = decimal 19, XON = decimal 17) are
AT+CSCS
interpreted as normal characters.
AT+CSCS="UCS2" 16-bit universal multiple-octet coded character set
(ISO/IEC10646 [32]); UCS2 character strings are converted to hexadecimal
numbers from 0000 to FFFF; e.g. "004100620063" equals three 16-bit
characters with decimal values 65, 98 and 99, $(AT R97)$
Extended Configuration Settings:
The AT^SCFG? read command returns a list of all supported parameters and
their current values.
AT^SCFG
The AT^SCFG= write command queries a configuration parameter (if no value
is entered) or sets its value(s). Input of parameter names is always coded in
GSM character set, parameter values are expected to be given as specified via
AT+CSCS.
Sets M20 compatibility mode:
AT^SM20=<CallMode>, <CmgwMode>
AT^SM20
0 - Set compatibility to Siemens mobile phones.
1 - Default mode
001-0003-829 Revision 1
Page 41 of 65
Advertisement
Table of Contents
